W201 carbon fiber door card Installation
- Prepare a table with a soft surface to avoid scratching
- Place carbon fiber door panel face down on table
- Place butyl strips, as shown. Ensure that the butyl sticks out so it will be squeezed when installed
- Set door panel in place on door - inserting the 'lip' into the top window seal
- Confirm left-to-right alignment before pressing panel into place
- Re-install door latch handle assembly. Press in and slide the door handle assembly into place, ensuring it hooks into the door frame
- Install the door striker bezel (little plastic piece on side of door fastened with one screw) Ensure it hooks into door frame
- Insert the door lock pin
- Screw in the door pull strap using the original door handle screw
- Install rear door window switch bezels. Press switch into 'stevs' bezel, connect to harness, and press into door card